-
Just like most comment here this is not an issue but I like to get some input and give some feedback.
To play around a little bit I did mount a 2W blue laser+MOSFET to my ShapeOko+grbl and it is work…
-
Hi,
I'm trying to read the firmware of CSR 8645 over SPI using Raspberry PI GPIO. The connection between the CRS 8645 and Raspberry PI should be right since if I used the file `./spidev_test -D /dev/s…
-
In case of hc05 setup we plan to use a free pin of Microduino board for bluetooth module setup.
-
It will be good to have method for retrieving data via AT commands. For example AT+STATE? should allow to easily retrieve INITIALIZED string or whatever status of the module is.
the method could be:…
-
Are HC05 modules with 3.3V TTL supported? If yes, must I connect them with voltage divider on RX contact?
-
This isn't a micropython issue, but I wasn't sure where else to post it.
I was trying to edit the page: http://wiki.micropython.org/official-accessories/Bluetooth-module-HC05
and when I click on logi…
-
Hi Mike!
I'm back again, this time with a few more optimizations to the FreeIMU library!
In `libraries/AP_Filter/Butter.h`, I had to remove the following condition checks in order to get Arduino 1.6…
-
```
What I'd expect to see is that Pybluez could inspect the services offered by
HC-06 modules, and that HC-05 modules in Master (Initiator) mode would be able
to scan and identify Pybluez-advertise…
-
Hello, I have a project called USB Typewriter, where I turn old typewriters into computer keyboards. I'm developing a new Bluetooth application and while I think your project is ingenious, I am havin…
-
I purchased a couple of these bad boys: http://dx.com/p/jy-mcu-arduino-bluetooth-wireless-serial-port-module-104299
They are simple bluetooth serial adapters that plug right in to my arduino. I've go…