-
The [SCD-30 datasheet](https://www.sensirion.com/fileadmin/user_upload/customers/sensirion/Dokumente/9.5_CO2/Sensirion_CO2_Sensors_SCD30_Interface_Description.pdf) mentions 3ms delays in these two sec…
-
Hi Team,
I had problems with reading measurement values with the latest release of the SCD30 with Embedded-SCD 2.1.2:
I got crazy values, which caused the crc check to fail, cause those values…
-
Steps to reproduce the behavior:
board: DevKit
firmare: rev822
sensors: SPS30 UART, SHT31
Battery powered: NO
Settings: UART
stime: 60
Debug: ON
WiFi: configured and working.
Log
Jun…
-
What are the connection pins of the scd 30 on the particulate matter sensor
-
These Stevenson screen enclosures are white so that they reflect most sunlight and avoid heating up (and therefore heating up the air in/around them). Painting them green is probably causing them to h…
-
Dear,
Thanks a lot for the new sensor. I'm amazed by the size and the ease of installation.
I used the example code to compare the behavior with the previous SCD30.
They are running next to each …
-
File "adafruit_scd30.py", line 183, in CO2
File "adafruit_scd30.py", line 234, in _read_data
File "adafruit_scd30.py", line 221, in _send_command
File "adafruit_scd30.py", line 221, in _sen…
-
The measurement interval setter works perfectly for the current execution...but if I start the 'usage example' a second time, the measurement interval is set to 2 again.
Am I missing something? (B…
-
I can't read with ESP32 with other GPIO's, I try to begin wire with Wire.begin(25,26) but doesn't pass the probe sps30_probe(). I can't find a method in the library for set other GPIO's to scl and sda
-
The code in the SCD30 examples for declaring the SCL and SDA pins does not compile as is with the latest cargo packages. I am not completely sure if the hal version changed or not, but Twim::Pins requ…