-
### The problem
I have updated my sonoff basic today.
After the update the sonoff was not available anymore in home assistant.
I bit the bullet and crammed it out the corner in order to reflash…
-
### The problem
When using the Pulse Counter Sensor pullups are active and can't be disabled (pullup: false does not do anything either).
If I configure the same Pins as simple binary sensor pullups…
-
Hi there,
Sorry, it's a bit out of scope but I wanted to dynamically set the "AC Charging power" value of my Delta Pro based on another sensor (excess of solar, basically), a bit like you do with t…
-
Core
2024.11.0
Supervisor
2024.11.2
Operating System
13.2
Frontend
20241106.0
日志记录器: homeassistant.config_entries
来源: config_entries.py:635
首次出现: 08:06:43 (7 次总计出现)
上次记录: 08:09:16
Error …
-
### The problem
honeywellabp2_i2c sensor only works with logger enabled to VERBOSE or VERY_VERBOSE. If I set the logger to default, then it fails with:
[12:51:57][E][component:082]: Component hon…
-
### The problem
One of my devices does not boot (or is in bootloop) after uploading the following code:
Unfortunately I also could not get serial log working.
The problem is on the addition of …
ksya updated
2 months ago
-
### The problem
More parasitic powered sensors on bus, 1k pull up. Seems like every time after reset it publishes 85. And sometimes repeated bus reset, so one of the sensors has 85˚C all the time.
I…
-
### The problem
I have a Midea-compatible ducted unit with the white circular/external smart wifi device, plugged into CN40, with a wired controller daisy-chained through it. I'm using the HVAC USB w…
-
**Describe the bug**
I can't switch fan moe to anything else than Turbo. If I switch to low, medium, or high, it switches back to Auto
**To Reproduce**
Steps to reproduce the behavior:
1. Go to …
-
The integration does not work anymore because myedenred has implemented 2FA.
```
2024-07-17 11:11:29.619 ERROR (MainThread) [homeassistant.components.sensor] Error while setting up myedenred platf…
taduo updated
3 months ago