-
```
What steps will reproduce the problem?
I'm not really sure how to reproduce the problem -- other than by regular
browsing.
What is the expected output? What do you see instead?
I see an "exte…
-
```
What steps will reproduce the problem?
I'm not really sure how to reproduce the problem -- other than by regular
browsing.
What is the expected output? What do you see instead?
I see an "exte…
-
```
What steps will reproduce the problem?
I'm not really sure how to reproduce the problem -- other than by regular
browsing.
What is the expected output? What do you see instead?
I see an "exte…
-
```
What steps will reproduce the problem?
I'm not really sure how to reproduce the problem -- other than by regular
browsing.
What is the expected output? What do you see instead?
I see an "exte…
-
```
What steps will reproduce the problem?
I'm not really sure how to reproduce the problem -- other than by regular
browsing.
What is the expected output? What do you see instead?
I see an "exte…
-
```
What steps will reproduce the problem?
I'm not really sure how to reproduce the problem -- other than by regular
browsing.
What is the expected output? What do you see instead?
I see an "exte…
-
Even though a g-code exists for this (G28.3) I think an API function to set an axis location manually to a specific coordinate should exist, and convenience helper functions should exist for it in fa…
-
Hey,
Just get back from holidays.
I updated the Engine to the last version.
I can use the keypad normally.
It is not possible anymore to 0 an axis and when I send a job, its status goes straight to 10…
-
In a a toolpath that involves pocketing a circle with a short step-over between each pocketing pass as in this view:
![image1](https://cloud.githubusercontent.com/assets/5035834/7346148/82dabcdc-eca9-…
-
Accidentally ran a metric file from Jonathan's thing ...
Took off to china, so had to stop with STOP. On restarting things, seem connected and communicating, etc. Z works. But X and Y totally dead fo…