-
I am using WRC-2533GST2 with latest 21.02 snapshot (MT7621A + MT7615N*2). Thanks for developers, both 2.4GHz and 5GHz connections are stable.
The problem is 2.4GHz RX is slow. TX is about 110Mbps, wh…
-
Hi,
I set up a 2,4 GHz AP using a Raspberry Pi 4B and an ALFA AWUS036ACM.
Besides the USB Stick (plugged into a USB2 port) only LAN and USB-C (for power) is connected.
iperf3 measures around …
-
Hi,
the last update, i.e. V9.0.21, helped me a lot when restarting the router every day, but after reconnecting the device it shows a strange IP address, not the one it was before.
Additionally,…
-
20 euro router everything works.
200 euro router not working.
Absurd that the firmware is not developed to give support!
I wanted a superior performance router and you can't use the mesh network ..…
-
This issue is to track hardware related issues like hardware specifications and configurations etc.
-
# include "navi.h"
CSINS::CSINS(void)
{
}
CSINS::CSINS(CIMU &imu0, CQuat &qnb0, CVect3 &vn0, CVect3 &pos0, CEarth ð0)
{
imu = imu0; qnb = qnb0; Cnb = CMat3(qnb); att = CVect3(qnb);
vn = v…
-
hi,
i am using tp link usb card t9uh ver 2.0 with drivers aircrack-ng/rtl8812au branch v5.6.4.2.
problem is that almost all 5GHZ ac channels cannot act as ac access point
```
Frequencies…
-
Speed Comparison Tests with Specific Commonly Available USB WiFi Adapters
Note: This is a limited test using a capability that all of the tested adapters have. All adapters were tested in the same …
-
*eaforlife:*
Hello,
Device: RT-N12+
Issue: WLAN is not working properly. When enabled the signal status shows 0db noise 0db. Wireless devices would properly show the SSID however unable to join. …
-
*eaforlife:*
Hello,
Device: RT-N12+
Issue: WLAN is not working properly. When enabled the signal status shows 0db noise 0db. Wireless devices would properly show the SSID however unable to join. …