-
I made a plate and wired it in no issue. Go to Probe tab and after positioning Z near plate, hit probe and it lowers until it touches the plate and stops. So far so good. Right now I'm just doing Z…
-
```
DRO von X zeigt immer den Radius an, ein Wechsel zwischen G7 und G8 führ zwar
immer zu den richtigen Fahrpositionen, man wünscht sich jedoch wie bei Axis
noch ein Zusatz DRO für den Durchmesser.…
-
```
Was muss man tun um das problem zu reproduzieren?
1. Mocca starten im Lathe Mode
2. NotAus raus, einschalten und alle Achsen referenzieren
3. Programm laden, z.B. Anlage
4. An eine beliebige Posit…
-
Hi,
I've discovered a couple more small quirks with grblControl:
1. M30 when executed should move the highlighted G-code line back to the first line
2. When creating an arc in the XZ plane the Arduino…
-
```
Beim Start von Mocca im Lathe Mode wird G17 als Aktiv gemeldet, es sollte G18
sein.
```
Original issue reported on code.google.com by `nie...@web.de` on 9 Aug 2010 at 5:58
-
```
What steps will reproduce the problem?
1. Run UpdateVersionNumber.exe
2. Set Version as 2.5.0.1176
3. Rebuild Duplicati.sln in release mode
4. Rebuild Duplicati Scheduler.sln in release mode
5. Re…
-
The player can enter his Land without actually having reeds around him.
That basically means one can get unable to keep playing once entering the Middle, as no way to get captchalogue cards will be le…
-
I am looking forward to a time where I may want to go to 4 axes. I have been reading the closed issues regarding 4th axis implementation and it appears that it is doable un an UNO/NANO board by using …
109JB updated
9 years ago
-
Hi all,
Just started playing with a clone of 'master'
Having an issue with M02 and M30 commands. When either of these are sent Grbl never responds. When using Universal G Code sender, the ok response …
-
When one commits suicide in edit mode with the /kill command, respawning puts them back to their out-of-computer gamemode. However, it applies once the item filtering process at respawn time.
To make…