-
After upgrading my 3D printer from Arduino+Ramps 1.4 and LCD12864 display to MKS Gen 1.4 with MKS TFT 32 display, I detected that the heatbed thermistor on this screen shows errors in temperature meas…
-
Hi,
Did anyone actually flashed the firmware posted in the repo the HEX or the actual files?
Or did some one dumped the firmware from the printer itself and compered it to the HEX?
-
### Description
When running command G29 to level the bed, some BLTouch devices drop the pin after *some* probing points. This **doesn't seem to affect** the actual probing measurements.
It is w…
-
Printer=HICTOP, Octoprint=1.3.12, Octopi=0.16.0, Firmware MARLIN 06.13.16 origin unknown
Issue with Dashboard plug-in.
On a fresh booted system the bottom line of the Printer display correctly shows…
-
### Description
Bigtreetech SKR Pro control board(STM32F4) does not seem to hold SD-based EEPROM to the on-board card.
### Steps to Reproduce
1. Load lastest Marlin 2.0 to SKR Pro
2. Make ch…
-
Help please!
```cpp
// A single Z stepper driver is usually used to drive 2 stepper motors.
// Uncomment this option to use a separate stepper driver for each Z axis motor.
// The next unused E dr…
-
Hi all!
I have a Azteeg X5 GT board with TMC2660 (Bigfoot BSD2660), and seems like Marlin has support for some types of TMC drivers. How to enable TMC2660?
-
I really like everything about the UBL system but unfortunately I can not get it to work properly to automatically build the mesh. Have been trying for a long time.
I can successfully build a UBL mes…
-
Let's coordinate the Marlin 2.0 RC1 release and track remaining work for this first release candidate.
### AVR
Board|MCU|SD Card|LCD|TMC SPI|TMC UART|EEPROM|WiFi|Max6675|Neopixel
-|-|-|-|-|-|-|…
-
Im write my own board variant for STEVAL-3DP001V1. All compiles fine. But in my board SPI drivers L6470.
When i use it in configuration - doesnt compile with errors.
```
c:\users\ffnul\appdata\loca…