-
Hi - I'm looking for a way to reset the position counter to zero after homing, similar to AccelStepper command setCurrentPosition(). Is it possible?
I'm using the TMC2130 SilentStepStick for sensor…
-
Dear,
First of all thanks for the code. I am trying to fix it with XY plotter drawing machine. I am doing exact with the same hardware what is given here: [xy plotter](http://www.instructables.com…
-
An issue that has been mentioned in passing is that we may run into a bottleneck when pulsing the stepper motors.
The problem potentially is that while driving in a very long straight line we may e…
-
This is a minor issue, but I just wanted to point out that the `stepperStep` command expects speed in .01 rad/s (or accel/decel in .01 rad/s^2). It works, but this is sort of odd and it should be poin…
-
Hello,
I noticed a strange behaviour while deceleration. It seems the speed was reduced until zero, not until pull in speed. Also there seems to be a jump from constant speed to a lower value at th…
-
Great job on this library! I'm having a problem though.. changing motor.setMaxSpeed to negative or positive is not changing the direction of the motor.
Here's the code I'm converting from AccelS…
-
hi im using esp8266 and i got this error
`chksum 0x2d
csum 0x2d
v09f0c112
~ld
ets Jan 8 2013,rst cause:4, boot mode:(1,6)
wdt reset
`
can help me. im new in arduino and this for my fin…
-
* Remove speed params in step
* Remove speed params in to
* Change set maxSpeed to speed (Stepper2 will figure out wether to use AccelStepper's setSpeed or setMaxSpeed command automatically, based o…
-
Hi
I am totaly new on arduino, and I do not know if this project is still alive.
Anyway I would like to build small 4 axis CNC router and see that yours project should filfull my requirements. But …
-
I am running 0.9j with a v3.51 grbl shield. It works well on my 4x4 foot cnc plasma table, but I am having a hard time getting a torch height controller to work. I programmed a second arduino uno to…