-
Hello,
I have quite some trouble getting SerialPIO to work.
I am using a Raspi Pico W with a NEO6M GPS Module. When I am using the Hardware Serial interface, I get the right data. When using the S…
-
This may turn out to be limited to Windows 7 Arduino 1.x users, and there probably aren't many of them, but I'm so far not able to use 4.0.0 after updating via the Boards manager, in Arduino 1.8.19, i…
-
I noticed that with the latest version my compilation failed.
the difference is that in `framework-arduinopico/variants/generic/common.h` the line
```
#ifdef PIN_LED
#define LED_BUILTIN PIN…
-
Hi there!
I'm working on a project which combines USB host functionality, FreeRTOS and a number of interrupt sources.
Every now and then the system panics with "IRQ stack overflow" which traces back…
-
Hi guys,
Trying to compile code and upload to my TTGO Lora32 T3_1.6.1. I can compile the source (firmware) without problems and it uploads to my device but when I run the pio monitor command I see I…
-
Could not detect the DGB tool path message appears in Exception Decoder Output window. IDE is 2.3.1, board ESP8266.
How debug output can be enabled? This could be helpful to find out such issures.
chked updated
8 months ago
-
Add capability to simulate multiple MCUs in a single simulation diagram.
Possible Use Cases:
- Prototype multi-processor systems - e.g. Multiple Slave MCUs processing sensor data (DSP algorithms…
-
### Board
ESP32-PICO-V3-02
### Device Description
Custom made PCB with a ESP32-PICO-V3-02 and a TF card slot. Since both reading and writing exsisting files works fine, I don't think it is a …
-
Hi I am having issue with your yaml, can you look over it, maybe you can spot the error. Thank you very much.
```
INFO Reading configuration /config/esphome/s3.yaml...
WARNING The selected Arduino …
-
Cut the CMSIS-DAP/debug console communication in the middle and put WiFi in between.
Pico at the target would be the AP, Pico at the host would be the STA. That means that the two Picos would crea…