-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Running a G28 results in Homing Failed when using Marlin 2.0.9.3.
### Bug Timeline
12/25/20…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
On Marlin 2.0.9.3, the thermistor and bed report -15ºC instead of the actual temperatur…
-
Because I reversed the Dupont Wire Jumper after installing TMC drivers.
So the firmware I updated is: `MEGA_S_DGUS_v1.4.0-b3.hex`.
It is in the right direction and no problems have been found so f…
-
I have an i3 Mega S with TMC drivers, DGUS 2 screen, BMG extruder, and BL Touch installed on Pin 4 using UBL. I have previously modified and compiled custom firmwares from version 1.16 through 1.3.0 …
-
### Did you test the latest `extui` code or prerelease?
Yes, and the problem still exists.
### Bug Description
I bought a new CR-6 SE about 2 weeks ago. I tested printing without upgrading th…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
I'm new to Marlin, and relatively new to 3d printing. This is my first printer, Ender-3 with 4.2.2 M…
-
### Bug Description
### Steps to Reproduce
Gestestet nur mit Version 1.3
Benutze testweise VSC + PlatformIO auf Windows nicht! Linux um die unterschiedlichen Firmwareversionen zu erst…
-
DGUS command not showing and I cant figure out why I have it set to stm32f103 and nothing.
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Hello so I'm just trying to compile a firmware for my E3V2 using SKR2_REV B (STM32F429)…
-
**Describe the bug**
gcode not working as intended. G29 S0 is used as Speed Rate rater than Slot which the mesh should be saved.
As per Marlin Documentation for [UBL](https://marlinfw.org/docs/gco…