-
@jordens is tracking design proposal/specification for Kasli on the wiki. Let's discuss PCB_kasli specification here.
https://github.com/m-labs/sinara/wiki/Kasli
How Kasli might interface to pe…
-
Current meter displays 0.00 both on configurator and on telemetry
Configurator 2.0.3
FW 2.02
Board Naze32 rev5
Updated with full chip erase from 1.12.1 when current meter was working properly.
p…
-
# 3. If you answered NO to the first question. Delete everything above this line, read the guidelines (see link above this form) and continue.
# A - Description
SP Racing F4 Evo isn't moving an…
-
Hey, i tried to upgrade my omnibus f4 yesterday, i used `dump` to find the firmware ( OMNIBUSF4 in my case ) and i launched the flash. Everything is working perfectly execepted the blackbox. I can't c…
-
For some reason I cannot get current telemetry on my Taranis. I am able to get VBatt telemitry, but no current info. Dump file below...
Any help would be appreciated.
CLI
# dump
# Cleanfligh…
-
Hallo, i have an seriously pro f4 evo board, an GR-24 Hott receiver and an Mx-20 transmitter. On der Fctrl I have 2.0.1
Im connected over UART 2 for the receiver an the 4th pin is UART 5 by soldering…
-
Hi,
tested the last stable versions .0, .1 and .2. The last version sonar is working on the CC3D was 1.13.0. 2016-06-06 22:20.
Did the pinout change or is it a bug?
At this point i also recogni…
-
I got an SPracing F3 clone here that used to work fine in 3.0.1 with the onboard baro. I'm just using it to display altitude on OSD.
After updating to 3.1.6, the baro is still detected, but always sh…
-
I'm baffled by an issue I can repeat without fail on a naze32 acro rev 6.
When powered by USB I set the `min_command` setting to 930 (not through the CLI, but the Configuration tab). I can save the…
-
I have activated Sonar, without Softserial, on version 2.0.1. Used port vor Sonar (io1 port 5&6)
No respons, measured with logic 4. Also no frequenty on trigger or echo.
do i have to use the special…