-
### Development Kit
ESP32-P4-Function-EV-Board
### Module or chip used
ESP32-P4
### Debug Adapter
ESP-PROG
### OpenOCD version
v0.12.0-esp32-20240821
### Operating System
Li…
-
I've been experiencing an issue where poor power rails cause the bootloader to be entered spontaneously. You can simulate this by applying power to a Feather M0 by holding the ends of two wires togeth…
-
Hello,
I've been using your ModbusSlave implementation and it was been working very well. I really appreciate the work you have done.
I'm trying to get your ModbusMaster implementation working and …
-
### Development Kit
ESP32-S3-DevKitC v1.6
### Module or chip used
ESP32-S3-WROOM-1
### Debug Adapter
ESP-IDF
### OpenOCD version
v0.12.0-esp32-20240821
### Operating System
MacOSX Sequoia 15.…
-
### Description
When I test ble case on 96b_carbon with multiple connection and disconnection, bus fault error occurs sometimes.
### Test Code
[/samples/BLE.js](https://github.com/01…
-
### Checklist
- [X] Checked the issue tracker for similar issues to ensure this is not a duplicate
- [X] Read the documentation to confirm the issue is not addressed there and your configuration is s…
-
Similarly to the USB-UART bridge, it'd be really useful to have an option to use flipper as a i2c device (Ideally both as a master and a slave that shares the memory to the host computer). Similarly a…
-
I can't seem to load the basic Blinky example via the board's DAPlink. I can upload to the Pico directly just fine but not with the baseboard. This is the error i get:
```
EXT: hex
Open On-Chip D…
-
If Zero board has the ability of being debugged, and the low-level tools (openocd, gdb) already exist and are shipped within the IDE, it's a pity that IDE doesn't offer a basic GUI interface to them. …
-
I'm trying to Debug a hello world application on HiFive Unleashed using PlatformIO Core (CLI) tool. I've setup the utility using this Wiki:
https://docs.platformio.org/en/latest/core/installation.ht…