-
https://speeduino.com/forum/viewtopic.php?f=12&t=80&p=16868&hilit=subaru#p16868
![image](https://cloud.githubusercontent.com/assets/138502/23540231/2218fe04-0034-11e7-9b56-187e8b6a9b35.png)
![im…
-
I think there might be a problem with the tooth logger in the October 2018 firmware. No matter what I try I can't seem to get it to generate any results. If I choose write to file, no file appears. I…
-
I've been trying to diagnose why some Speeduino users are having trouble with MSDroid (I'm a sometimes developer on MSDroid) and it seems there is an error in speeduino.ini.
The current pageReadCom…
-
I have successfully bench tested 4S staged injection.
But I plan on running my Speeduino V4 on a 2S and I don't think things are working properly in staged 2S mode. The secondary injector does n…
TZ350 updated
6 years ago
-
Summary here is that the stepper cranking table is not being read correctly, which causes huge stepper targets that the system can't meet due to int values being read from a byte based table.
See t…
-
April rls code.
Speeduino.ino ln 248.
configPage2.pinMapping - which board I'd to use; can be > 100.
BOARD_NR_GPIO_PINS - the number of pins defined for board; defined for Teensy as 34. ( should…
-
As previously discussed on Slack for a "reverse" checkbox in TS, and one code solution posted and tested here .
---
Did you help close this issue? Go claim the **[$5 bounty](https://www.bounty…
-
Speeduino users could benefit from more than 1 or 2 squirts-per-cycle for a number a useful reasons.
Beyond the obvious potential for improved fuel distribution in certain engines and setups; ultim…
-
Decoder for newer Toyotas, pending waveforms
-
Currently the cranking pulsewidth adder is only a single value.
Request is to add a basic curve (Probably 4 points will be enough) based on coolant for the cranking PW rather than this single valu…