-
Hello! Just started using DSD-FME.
I noticed that after you connect TCP (i use SDRAngel) and DSD, in case of connection timeouts or goes down (ie i switched something in SDRAngel that took several se…
-
### Enhancement summary
the options for ```switchport phone trunk``` currently are ```taggeed | untagged```.
```
# Switched Interfaces
ethernet_interfaces:
:
phone:
trunk: < tagge…
-
Well, I never tend to use this input method, but its always worked 'fine' for me when the signal is good. I went back and reviewed a lot of the code for the implementation, and realized that its bust…
-
I've identified an issue where the SACCH Superframe and its CRC Validity isn't reset often enough (it happens quite a bit) but more specifically, we need to reset the entire structure after reading in…
-
The goal would be a way to display system information about the number of calls currently being recorded and information about the trunking system. This information would be sent out as JSON over a lo…
-
No matter how I run this and pipe inputs I can't get the "In Level" above 0%.
I've tried:
1. Routing pulse audio in via the virtual sink from SDR++.
2. SDR++ TCP network routing. Then running `dsd-…
-
Inter-router linkage between a router with connection-trunking (#703) and a router without it causes rejection of link attaches for streamed links. Modern releases should be made compatible with olde…
-
Adding EDACS to this would allow all the current trunking protocols to be supported.
YES, I AM AWARE EDACS is EOL and Harris is trying to KILL IT for P25. BUT...
[EDACS.c.txt](https://github.co…
-
Radios are showing as site trunking while dvmhost is connected to FNE. Verified connectivity to FNE as ADJ STS BCAST messages are passing in both directions.
-
Out of the blue I am constantly getting a "connectex: A connection attempt failed because the connected party did not properly respond after a period of time, or established connection failed because …