-
The stepper drivers on the Ender 3 V2 are in standalone mode, and their current cannot be adjusted via klipper/firmware. It might be wise to just put a quick note in the Dual Z readme page that the gi…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
The firmware doesn't support full functionality with new GD chips. I went ahead and fl…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Hello, when i tried to compile Marlin 2.0.8 by this tutorial: https://www.youtube.com/w…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
This bug is present in the CR6-SE Community Firmware at Release 6, which incorporates M…
-
### Is your feature request related to a problem? Please describe.
I am trying to make a custom control board based on black pill(STM32F401CDU6) because it widely available and cheep.
…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
I have bltouch on my printer and when I enable Power Loss Recovery, as soon as it switc…
-
### Description
Can't build on MOTHERBOARD BOARD_CREALITY_V427 using various environments.
### Steps to Reproduce
On latest commit on main Jeyers branch. I have a Creality v4.2.7 STM32F103RET6…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
When moving to a new SKR mini V3.0 the VS Code stopped compiling with following errors:
Co…
-
I have been struggling with consistent layer shifts (not always at the same layer) printing thorugh Octoprint on my Prusa MK3S. Layer shifts are on the order of 0.2 to 0.5mm can would typically happe…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
I tried to build with platformio using vsstudio to use bltouch in my ender3, but I got an err…