-
**Hi all,**
I have a problem that in webContro{duet 2 wifi}l all files are multiplied several times. For example if i create a filament (ABS) I get numerous files named ABS and also in system editor …
-
Hello,
I've some lost connection this WE on my Duet Wifi. I was on 1.21 Firmware and Running my 3D printer for 6 months without any issue.
I've upgraded to the latest relase 2.01, upgraded the …
-
how would one go about adding support for a SAM3X8C based controller?
I have the pin configuration file. I'm just not familiar with 32 bit controllers and don't quite know where to start.
https://gi…
-
I started a long running print last night. Shortly after starting the print I reset my WAP for an unrelated issue. The Duet Wifi did not reconnect to the AP. It has been printing fine for 12 hours so …
-
could I get a pinout from the motion controller, please?
A schematic circuit diagram like the one offered by Duet?
Many Thanks
-
In marlin compatibility, **missing '\n'** after "OK" response when M20 command is used.
FIRMWARE_VERSION: 3.1.1
```
Begin file list
text.gcode
End file list
ok (here missi…
-
### Version
2.3.0-rc2+win64
### Operating system type + version
Windows 10 Pro 20H2 19042.685
### 3D printer brand / version + firmware version (if known)
Custom CoreXY, RepRapFirmware for Du…
-
Hi,
first and foremost I would like to bring this issue to attention where we can track it all together properly. Discord doesn't seem the right place for me as messages and focused discussions get o…
-
The release 3.2beta2 seems to have a problem when running M702 or unloading filament.
I've tried uncommenting the gcodes inside the macro, but that didn't help.
Duet crash and reset itself immedia…
-
There is a board on ESP32. Compiled the firmware based on Marlin 2.0.9 and Esp3dlib. But there is no connection between the WEB interface and the firmware. A similar GR BL firmware works on this boar…