-
```
What steps will reproduce the problem?
1. setup an OVH account
2. call an OVH line 09xx it's working
3. call an OVH number +33183xx doesn't work
4. call an OVH number 0183xx it's working
5. call…
-
```
Tested with open9x for sky9x r1362.
A beep is played instead.
If i push forward THR and move a switch before powering on the radio the
Throttle alert is a beep and the switch alert is ok (voice)…
-
```
This little behaviour is not critical but i've been trapped with it many time
when powering up the radio and wanted to immediately change the model.
To make it happen: Power the radio and within…
-
```
Actually when a wav is played, it is until its end.
With that behaviour you can easily miss other voices messages.
For example when enumerating 3 pos switches value with voices, the last spoken
…
-
```
Delay in a mix is OK when source is a switch, but when switching to a pot, a
channel input or a stick value it goes like there is no delay.
For slow up/down the problem doesn't exists.
I observ…
-
```
What version of the product are you using? On what operating system?
i am in Windows 7, 32 bits
and i just took the premotedroid on the android market (april 2010)
Please provide any additional…
-
```
I get better results for midpot with BEEP_DEFAULT_FREQ rather than
BEEP_DEFAULT_FREQ + 50
For no activity beep that's the second time i left my radio inactive and didn't
hear the warning (It ne…
-
```
On Open9x 1195 for sky9x board.
If a custom switch is set like:
SW1 = "V < ofs" "A2" "11V"
It will always be true when telemetry is not OK.
So when you're working on your radio without the RX po…
-
```
This is an early bug report, it happened two time on my sky9x board (open9x
r1353) but i'm not completely sure of how.
When turning on the radio i'm stuck on the bootup screen (capture attached)…
-
```
It's very easy to destroy a curve when trying to edit it because curve type is
already selected and a press of LEFT or RIGHT directly change it.
I'd prefer having to press MENU before it can be c…