-
hey there,
in ESPHome 2023.10 I contributed some patches to support the internal CAN controller (our heatpumps need 20kbits) of newer ESP32 chips (see https://esphome.io/components/canbus.html?hig…
-
Hi there,
Thanks for your contribution, i don't think Bart ever tested or designed for a two Zone system. Any plans to integrate?
-
I have been using the Gecko integration for two years now and starting up again after winter I'm experiencing the following problem:
Temp changes or turning on/off lights _**from the spa panel**_ a…
-
In heating mode, if I have the tolerance set to 1F and the precision to 0.1F, and the setpoint to 68F, it turns on at 66.9F, but turns off right away when it gets to 67.1F. I would expect it to turn o…
-
Internal Ports - Old discussion:
* We don't have information about the internal connections e.g. a heatpump with 4 ports.
* If existing we can use information by port fluid to distinguish between the …
-
**Describe the problem you have/What new integration you would like**
I would like to have Gree AC with YAY1F1 remote to be supported for IR Remote Climate.
None of these available models work…
-
My installation:
Vaillant AroTherm+ 105/6, VWZ AI (only 1 temp sensor + ebus), Thermostat VRC 720f, VR912 (sensonet gateway). Ebusd is connecting to the ebus interface over WiFi, powered by an ipa…
-
-
Like some online shops have for products, allow user to select up to (say) 4 heat pumps and compare them.
Heat pumps would be present as vertical columns, with stats as rows. This would show some o…
-
We repeatedly get questions about our calculations for transport demand. It would be efficient to write this down once properly and then be able to refer people to our documentation.
The main quest…