-
Hello
I can't find the mac address of the JKBMS, could someone tell me where I can find this information to insert into the code
THANKS
-
I set up a node-red flow to read the max cell voltage (esp-home + jkbms) and then decrease the max charge current when it started getting too high.
It seems that set value was called on way more t…
-
**Describe the bug**
Im not sure, if this is a bug or a missing feature;)
I connected my JKBMS with this lib , thanks for the good work !!
Inside the Venus I get all the values like SOC and Consu…
-
### Describe the bug
I have two JKBMSs connected and try to rename then Battery1 and Battery2 respectively
The names are excepted and presented properly till the unit is rebooted.
Once the…
-
### Describe the bug
After uprading to the latest release the battery stopps charging at ~55,12 v but the end voltage should be 55,2 v.
![image](https://github.com/Louisvdw/dbus-serialbattery/as…
-
### Describe the bug
Attached is a Screenshot. On all Solarchargers connected to the Victron System,
I get spikes in the power-values when serialbattery is used.
I don't geht them if i do not use …
-
Hello
I know that there is a slightly different protocol here, but maybe you can help me with these two values?
I got a new JKBMS:
(JK-BMS has the hardware ver V11.XW - software ver V11.26 and vers…
-
### Describe the bug
I got this error message after "bash /tmp/install.sh":
tar: conf/serial-starter.d: Cannot open: File exists
tar: Exiting with failure status due to previous errors
How to …
-
Hello
my esp32 is looping on bluetooth connection attempts with my JKBMS. Once out of 100 he connects to it then it's gone again...
What to do ?
Thx
-
### Describe the bug
I noticed that the CVL reset also happens at SOC_LEVEL_TO_RESET_VOLTAGE_LIMIT
even if linear mode is enabled.
I have a SOC drift of the JK BMS in summer so I selected the M…