-
### Creating a bug report/issue
#### Required Information
- DietPi version |
```
G_DIETPI_VERSION_CORE=8
G_DIETPI_VERSION_SUB=17
G_DIETPI_VERSION_RC=2
G_GITBRANCH='master'
G_GITOWNER='Micha…
-
### Creating an image request
#### Formal device information
- Device name | Orange Pi Zero 3
- Official product URL | [OrangePi.org](http://www.orangepi.org/html/hardWare/computerAndMicrocontrol…
-
rock5a do not has a spi flash, where should we flash the uboot-with-spl.bin into?
-
Running with our 2023-09-29 demo branch image, I got the following crash while sitting in user level GDB doing some debugging (although it was idle when it crashed). The desktop was running on the sys…
-
I'm using STM32MP135f-dk Development Board with ESP32 as Wifi Module. I removed the Murata Wifi/BT Module (sdmmc2 in Device Tree) and attached the ESP32 with Data[0-3], CMD, CLK, Reset, GND. ESP32 is …
-
EMB-3531 dts出错很少,dts算比较完善。
kernel可能有问题,刷完后,kernel启动阶段后会随机启动失败
串口输出如下
In
Channel 0: DDR3, 933MHz
Bus Width=32 Col=10 Bank=8 Row=15 CS=1 Die Bus-Width=16 Size=1024MB
Channel 1: DDR3, 933MHz
Bus W…
-
Hi Amine (@chalandi) here is the pi spigot benchmark project posted in its entirety, as we have discussed several times ni offline chats.
At the moment, I use your OSEK from [Chalandi/OSEK_Raspberr…
-
This appears to be a flake, just seen so far on aarch64:
```
18:19:38 --- FAIL: ext.config.shared.networking.nameserver (605.25s)
18:19:38 harness.go:103: TIMEOUT[10m0s]: SSH unsuccessf…
-
this only reproduces when more than usual cross-dpaa interface traffic is present.
I can trigger it using iperf3 reliably. This is using normal CURRENT, not fork.
```
$ iperf3 --parallel 16 --cli…
-
I'm not sure what is going on here, but after running the new ControlNet nodes succesfully once, and after the Colab code crashed, even after restarting and updating everything, timm package was missi…