-
### Board
ESP32S3
### Device Description
DevkitM1, plain board, both USB ports connected to host
### Hardware Configuration
Optical sensor connected to GPIO21, GPIO38, GPIO47, GPIO48, GND and 3v3…
-
previously discussed here: https://github.com/tooyipjee/Spark-Analyzer/issues/2
it seems that the WebApp_PPS falls back to delivering 5V if the power supply is not PPS capable. This could lead to p…
-
Using 0.6.16 SPI Flash uboot. Booting from USB 3.0 to SATA cable with SSD encounter below error around 50% chances.
Model: Pine64 Rock64
DRAM: 4 GiB
MMC: rksdmmc@ff520000: 0, rksdmmc@ff500000…
-
I was not sure where to ask you questions, as I don't have your contact details: This project is just a gem! I stumbled across this series of projects after more or less giving up on trying to send da…
-
1. 1 x EtherCON In-Line Adapter - https://onecall.farnell.com/neutrik/ne8fdp/in-line-adapter-rj45-8p-jack-jack/dp/1202032?st=ethercon (£12.98ea)
2. 4 x Servo motors - https://thepihut.com/products/to…
-
Hi,
Does anyone know configuration for MKS Sbase with this sensor for dual switching extruder?
I have problem with compile. Runout sensor is 2, but i have only one stepper motor.
#error "NUM_RUNOU…
-
Costs could be significantly reduced, if this could pull reader data from an SPI-based rc522 instead of USB. I am looking at combining this project with SPI reader discussion at pimylifeup (dot) com/…
-
在openocd中下载文件时，出现了Info : This adapter doesn't support configurable speed的输出，是否意味着本项目的JTAG时钟频率是写死的无法修改呢？如果时钟频率只能选择最高，在从机速度慢或者接线条件差的情况下是否会导致无法使用的问题呢？
-
First time using pico_sdk, btw
cmake failed. Just built pico-sdk and picoprobe successfully
--------------------
```
myname@computer:~/Git/pdnd-picoprobe$ git pull
Already up to date.
myname@com…
-
If you getting `EOVERFLOW` out of nowhere - be aware of this line:
https://github.com/bm16ton/ft2232-mpsse-i2c-spi-kern-drivers/blob/923b7059795bcba5d82a3ae0a9fc7de93c20df03/i2c-ftdi/i2c-ftdi.c#L45…