-
Is there a guide on adding a new machine config to build VenusOS for?
I would love to be able to run VenusOS on my lePotato boards. At first I had hoped that VenusOS was a version of Raspbian so I …
-
Hi mr-manuel
Tried to use your backup script on a raspberryPi 3B using VenusOS 3.00-32
The backup breaks up in the middle and I assume, that the share cannot be mounted as the script cannot unmoun…
-
**Describe the bug**
During startup of serialbattery the values printed seems not to be correct. However, viewing cell voltage level via console seems to be right
**To Reproduce**
Use Jbd bms and…
-
My installation:
- 3 phase Multiplus II 5000/48: Firmware 500
- 4 battery banks (each LiFePo4 with eve 280Ah) with JK BMS : B2A24SP15-CAN
- Cerbo GX: VenusOS 2.93
- Lynx Shunt
- MPPT RS 450/20…
-
Hello,
Is it possible that this driver does not work with a Daly BMS?
These are the errors I get when the driver is installed:
INFO:root:2023-04-19 10:18:09.839286: Searching batteries: Tri…
-
**Describe the bug**
After finally (after some bumps) finishing the installation of Dbus SB I found that a sudden Grid feed-in of >4000w was taking place.
I just installed dbus-serial battery driv…
-
Hello,
my Multiplus II keeps changing between charging and discharging at MAX_CELL_VOLTAGE = 3.45 (55.2)
Every 10 sec or so.
Is this a normal behavior, or did I miss any settings?
Versions:
…
-
MQTT things stop receiving values after a null message has been send by the broker. Other clients, such as mosquitto_sub, continue working, therefore it seems to be a bug of the openhab MQTT plugi…
-
JK BMS looses connection after battery high voltage alarm.
**VenusOS
- Device ty…
-
I have tried various combinations of paths, including one in /home/pi/Documents/ and this one in the root, with different settings for permissions as either pi or root as owner and ability for all use…