-
Using @matheo-lucak 's fork of `rust-radio-sx127x` I finally have some examples compiling with `embedded-hal-1.0.0` on `stm32f4xx_hal` and forks/branches of `stm32g4xx_hal` and `stm32h7xx_hal`. (Detai…
-
There are lots of inconsistently implemented features in all in-tree platforms which should obey the same internal API.
The actually-invoking-UB one is `platform_target_voltage()`, see #1866. But als…
-
Can you please add support for bluepill and blackpill stm32f103c8
Upload protocol = serial
-
Would it be possible to have the ESP32-S3 show up as a USB Sound card? Then whatever audio it receives from the host would get sent out as I2S to a DAC (like the PCM5102A). I found this exact same thi…
-
### Operating System
Linux
### INFO_UF2.TXT
-none-
### What happened ?
Cannot compile the board as in the tilte described
### How to reproduce ?
.../tinyuf2$ python3 tools/get_deps.py stm32f4
…
-
In Arduino IDE, when trying to compile the code, and error message, "min was not declared in this scope" pops up. Any Solution?
The Full Error Messages:
Arduino: 1.8.10 (Windows 10), Board: "Gen…
-
Hi.
I made some tests with BlackPill (411, firmware from Web Builder) connected to two generators, one 3200 Hz as pulses, and second 1 Hz short pulses as index.
I surprised the G33 (and G76 too) wo…
-
A documentation explaining how to upload a simple blink program could be a great value for this board. Such example is very valuable for people starting using such a new board.
I looked for such exa…
-
Is there a way to change serial port for RTU comms to Serial1 so that I can do two simultaneous rtu loops (one slave one master) on half duplex?
-
Is it possible to control the LEDs of the blackpill?
For example I'd love to completely turn the red LEDs off. Or better yet, turn them on when I'm switching layers.