-
First off:
hanks for CAMotics. It such a useful tool for me atm.
One thing that would be great to change:
Whenever I start CAMotics the resolution jumps backs to "Medium".
I always have to go …
-
I am thinking of brute forcing a problem here. The problem: It is not unusual for a tool to run into a clamp.
If Camotics would show where it milled through a clamp, people might save a bit and cl…
-
I would like to be able to use CAMotics again but there are no RPM's available for current system. Have tried to install the rpm's as directed from pkgs.org, that I have found, but keep having depend…
-
G83 and G73 are currently unsupported (as of 0.4.3). Rocky Evans is asking for this capability. We should consider implementing all of the canned cycles listed in LinuxCNC documentation. They are G80,…
-
Implement polar coordinates
https://linuxcnc.org/docs/html/gcode/overview.html#_polar_coordinates
Controller errors out reading "@" and "^" charachters.
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
This appears to be an edge case where the path generator creates a large-radius arc (radiu…
-
Since building from source can be finicky (V8/ChakraCore needing to be exported variables for cbang to compile properly, not much documentation about V8/ChakraCore in general) as well as the Debian bi…
-
I built the code on Debian stable, and I get this when I try to run it:
```
#
# Fatal error in , line 0
# Embedder-vs-V8 build configuration mismatch. On embedder side pointer compression is ENA…
-
This may be a RTFM issue, but I'm starting to see a consistent issue where my sims local don't match machine max values. For example the same file on local CAMotics vs Buildbotics controller sim. Th…
-
G73, G76, G81-G89
Also update this page when fixed: https://camotics.org/gcode.html#missing-linuxcnc-codes