-
Hey. I have a CNC setup using ESP32 & Raspberry PI. ESP32 is programmed with grblHAL software.
At the moment, I am manually controlling the spindle. The controller that I use:
Optidrive ODE-3-220…
-
Hello.
Could you please help me with right hex for ethernet board. My cnc has 2 motors on Y so I want to use auto square Y when homing. On a board itself I cut 2 connections and bridge other 2 based…
-
For implementing spindle sync for further drivers.
-
Hello,
can you please add support for this?
http://fightpc.blogspot.com/2014/10/vfd-control-with-arduino-using-rs485.html
-
I have several people interested in using grblHAL with servo motors (not the RC hobby kind). These have an error signal that gets asserted when something bad happens - like losing steps. I think the …
-
> Big mistake by me when creating this driver, I have used Arduino code for handling GPIO pins resulting in a huge latency for setting step outputs (500 ns per pin), and it will be a while before I am…
-
In grbl/config.h, line 38, set N_AXIS to 5
`#define N_AXIS 5 // Number of axes`
and compile. Get numerous errors of the form
> D:\Documents\Arduino\libraries\grblHAL_Teensy4\src\T41U5XBB_map.h:2…
-
Wondering what blockers there are to trying to map to bart's v4 pinout? May make it easier for folks who can't fab a board.
Here's what i've collected so far on the mappings:
![grblpins](https:…
-
I am trying to use Universal G-code Sender with grblHAL on a MAC and Pi4.
I get a connection, but when every I run a command I get the error "Grbl has not finished booting. I am using version "grblHA…
-
You've probably already thought through all of this but can't hurt to write it down.
The options string should capture all (as many as possible, anyway) configurable options. Certainly from config…