-
Hi,
I have an ESP32 from node mcu (see the figure below for the pinout and the board specifics.
I think the pinout is not exactly the same as what's mentioned in the readme. Is my understanding…
KASR updated
2 months ago
-
Hi I just upgraded to the ESPHOME version.
When I send the command 'auto' the unit doesn't seem to respond.
I am able to set other settings like e.g. : 'ventilation_level_3'.
I have used the old ve…
-
Hello Emptygalaxy,
I need Help :-), do you have a idea ?
```
[homebridge-comfoair] This plugin generated a warning from the characteristic 'Filter Life Level': characteristic was supplied ill…
-
Today the temps dropped below zero and I noticed that one temp started showing wrong values. Since it was OK for T >0 I checked the code where it was declared as _uint16_
message.cpp, line 186:
` …
-
I am using Comfoair450 with LAN adapter and would like to connect it to my homebridge.
Now I found the plugin by npm and wondering about the values of configuration.
Where do I find the info abou…
-
Hello,
I make various pcb boards and I have a proposal to make a professional board for this project. I wanted to add MQTT broker control over ETHERNET, is it possible to rewrite the software under …
-
Hello,
I installed aiocomfoconnect and discovered the bridge successfully.
However, when trying to register aiocomfoconnect, it does not show any results and freezes.
This is with a dietpi and a…
-
Hey there, I successfully got this to work on my ComfoAir Q350 and it's publishing fine to MQTT (and OpenHAB) and I can see the graphs in Grafana. So far so good, however the rate of information is ra…
-
### Feedback
The documentation should state that the values are only valid when the comfoairq is 'alone'.
I have a comfofond 'in front of my comfoair'.
Comfofond-sensors are missing in the interf…
-
For some reason I'm not getting the operation hours anymore, these were working fine, and I cannot pinpoint the time it stopped working..
I've the following checksum error while getting operation h…