-
I recently purchased this adapter, ~~and was disappointed that it did not work out-of-the-box with retroarch: while 9 N64 buttons did get detected, 5 did not trigger any event.~~
~~I dug a bit, and…
-
I'd like to suggest a potential alternative to the Cypress board: [My USB Floppy Adapter](https://github.com/roybaer/usb_floppy_adapter)
It uses the same [STM32F103C8T6](https://www.st.com/en/microco…
-
(update top-level post by ian5v request)
TLDR as title.
Longer explanation:
Observed poll rate with the PIUIO is limited to 250 Hz, but it should be _at least_ double that. To observe this, pla…
-
After following your instructions:
/Xilinx/libxpc$ sudo apt-get install libusb-1.0
Leyendo lista de paquetes... Hecho
Creando árbol de dependencias... Hecho
Leyendo la información de esta…
-
I'm attempting to build the EZ-USB-FX3 SDK for Linux. When I run install.sh (located in (~/Cypress/cyusb_linux_1.0.4) I get the following errors:
sudo ./install.sh
Your current directory is ~/Cypr…
-
Spent the day chasing rabbits down the wrong holes trying to get the scope to communicate with OpenHantek - then I realised it was right in front of me
Bus 002 Device 032: ID 04b4:8613 Cypress Semi…
-
Hi Alex, because that short-circuit issue under the FPGA I decided to take a different approach: starts from basic and get USB Host working first!
I soldered only the USB Host on another board (all…
-
Can't seem to get it to finish creating the necessary nodes.
Running Lineage 18.1 as of yesterday. Samsung A5 (2017)
[*] ConfigFS seems to be mounted...
[*] ...and usb_gadget is available
[!] us…
-
Continuation of #759 and #749, specific to SuperSpeed and High Speed USB isoc transfer.
* #759
* #749
* #1069 (for bulk transfer but may help isoc case as well if we use the same approach for isoc…
-
I'm facing an issue in mounting usb formatted in ntfs. Kernel 4.13 in antergos with gnome.