-
### The problem
In the standard installation the "equipment id" is not propagated, but it is supported by all electricity meters.
I have several electricity meters and this helps identify them on …
hvegh updated
2 months ago
-
### The problem
I have two P1 meters connected to a ESP32-C3.
It appears this only works correctly if the sensor list for both instances are equal.
As soon as the defined sensors for each insta…
-
**Describe the problem you have/What new integration you would like**
A complete example of hardware that can be used with the esphome dsmr implementation
**Please describe your use case for…
-
My main meter is being replaced, and I went from DSMR 2.2. to 5.5. The updates of the entities which. belong to the SMR 5.5 are 5 seconds in HA.
The updates of my SolarEdge entities are 30 seconds. I…
-
I downloaded and setup new data from the Jacksonville data from [Spacenet.ai](https://spacenet.ai/core3d/) and set it up according to the requirements. However, even after the a JAX_[AOI_ID].dsm exist…
-
I have a 4 in 1 RM TX16s and an RM Pocket with a 4 in 1 module. I have set up the wireless trainer facility successfully in both directions i.e TX16s to Pocket and Pocket to TX16s by swapping the 4 i…
-
When looking at the graphs on iOS, Microsoft Edge (127.0.2651.74), Firefox (128.0 and older) some graphs have a black line. Even though the colour should be blue, according to the legend.
This can …
-
**Describe the problem you have/What new integration you would like**
The DSMR version installed in the smart meter is version 5. But the following data are not provided:
Energy Consumed Tari…
-
**Describe the problem you have/What new integration you would like**
Tried the DSMR integration to read my smartmeter, but it looks like there is an other but similar protocol in use for my Siem…
-
Hi Matthijs,
I have seen reports that belgium smartmeters do not parse correctly using the 5.0.2 dsmr parsing. This is due to the extention made by the Belgium netbeheerder.
The document for Belg…