-
Would be nice to seen the fans in %.
I keep my fans ~70% by controlling it with the power limit.
My neighbors don't like if my fan speed is 90-100%.
-
### Application [Required]
Intel Arc Control
### Processor / Processor Number [Required]
Amd 7800x3d
### Graphic Card [Required]
Intel Arc 750
### Rendering API [Required]
- [ ] Vulkan
- [ ] Op…
-
I am using some Leviton D24SF ceiling fan controllers. Matter firmware is not available for this member of the Leviton 2nd gen wifi switch series yet - presumably because of the partial ecosystem sup…
-
fan2go is unable to set the fan speed on my system
fancontrol and coolercontrol can do so just fine, enabling the corresponding services one-at-a-time.
But when I do `sudo systemctl start fan2go`,…
-
### The problem
Calling fan.decrease_speed seems to only work once, and subsequent calls do nothing.
I have a fan with three speeds, so the increments are 33%. The options are 0%, 33%, 67%, and 10…
-
### Is there an existing issue for this feature request?
- [X] I have searched the existing issues
### Is your feature request related to a problem?
Have feature specific fan control speeds been ad…
-
The fan script did not work properly after installation, so I had a look at the service:
```
pi@raspberrypi:~ $ sudo systemctl status x-c1-fan.service
● x-c1-fan.service - Daemon to monitor and co…
-
### Application Version
4.13.1
### Platform
macOS 12.2
### Printer
Ultimaker 3
### Reproduction steps
Load a 3d object.
In "Cooling" set "Fan speed" to 50%.
Slice.
Save to disk…
-
Hi, I have set up a Capability with a device template of type Range. The Device Name is "Living Room Fan" and Range Name is "Speed". I have set up values from 1 to 6, and have given preset names too…
-
@openhab/core-maintainers: is there any guidance on the preferred way to model a multi-speed fan (with discrete speeds between 0 and some number less than 100 - usually, between 2 and 10…