-
I tried to run 3.5 inch LCD with driver ili9488 in 4-line SPI mode on fbtft overlay, but this driver (ili9488) does not support RGB565 mode in 4 line SPI. If driver init with RGB666, then i`m take wro…
-
the LCD display should be driven by SPI commands. and you use the FT232 USB to SPI chip. how you translate the SPI commands to USB commands in order to control the LCD ? how you convert the current F…
-
Hi thanks for your great work and contribution.
can i use your USB display driver in order to drive ILI9163 FBTFT display panel connected to USB-To-SPI bridge (FT232H for example) ?
the data path f…
-
I'm working on a Kivy app that runs on an FBTFT display. The display only supports 16-bit color, and Kivy fails to create a Window on it. I found a workaround, as detailed here:
http://forum.odroid…
-
This could be a documentation issue but it would be nice to support scripts for the Waveshare Spotpear TFT Touchscreen along with the others included in your image. http://www.waveshare.com/product/mo…
-
Thank you for such great and easy build tool setup!!!!
Please advise on how to enable this 1.14" 135×240 SPI LCD (It is my first time with buildroot)
https://linux-sunxi.org/Sipeed_Lichee_RV
A…
-
TFT LCD를 동작을 확인하시기 전에 다음과 같은 SPI 설정을 미리 해주신 상태에서 채점을 해주시는 건지 질문 드립니다.
$ sudo modprobe spicc
$ sudo modprobe fbtft_device name=odroidc_tft32 rotate=270 gpios=reset:116,dc:115 speed=32000000 cs=0
…
-
Sir
i need to know how to install piTFT driver for any other image file other than Raspbian. Actually, I am using Yocto project to build my kernel image, now I want to install this driver within to se…
-
I use Model B+ on Jessie
1. Open SPI
2. sudo nano /etc/modprobe.d/raspi-blacklist.conf -> #blacklist spi-bcm2708
3. sudo REPO_URI=https://github.com/notro/rpi-firmware rpi-update
4. /boot/config.txt -…
-
Hi @stsrc
I want to interface the display to my RISC-V processor on linux. Can i directly add your kernel drivers to the linux kernel and start using it. When I inserted the kernel module in the use…