-
After loading the CDC firmware, sometimes you can't load the firmware again. Instead fxload dies with the error;
`can't modify CPUCS: Protocol error fx2`
-
A quick googling doesn't seem to turn up any public information on the UXN1330 board.
A board with Cyrpress FX3 USB 3.0 microprocessor and Spartan 6 / DDR Memory sounds very interesting to me and …
-
_From @mithro on July 17, 2015 7:30_
The FX2 should be loadable with firmware which makes it appear like a CDC-ACM serial port and is connected to the FPGA.
The FX2 has its two hardware UARTs connec…
-
`openocd` that comes with buildenv as a conda package fails to flash image on the FPGA flash, it looks like it has some kind of communication issue because the flash `ID` is detected as `0x00ffffff`
…
-
Using an alternate firmware, you can use nanoDLA as a SWD Debug Adapter.
It is a port of CMSIS-DAP, so openocd , pyOCD and probe-rs based Rust tool all work fine.
https://github.com/elfmimi/libfx2…
-
Hello,
I have tested this tool in the past and I know it used to work. But for some reasons I can't make it work in my environment (latest version of Ubuntu 16.04). I have installed everything as pe…
-
would be lovely if we could map `LFO` and `SLFO` to `FM2`'s `M1 Ratio` and `M2 Ratio`.
and also map `LFO` to `HP`, `FX1 Send`, `FX2 Send`.
(note, `SLFO` can already be mapped to `HP` `FX1 Send`, `F…
-
### 구조
- 파이프라인 통계
- 파이프라인 하위 팀 개별 통계
- 파이프라인 하위 팀 개별 통계
### example
- fx
- fx1
- fx2
-
http://sigrok.org/wiki/Fx2lafw
Continuous sampling seem to be common quiestion from new DSLogic users.
Sigrok has support for it in form of http://sigrok.org/wiki/Fx2lafw
It would be quite easy to …
-
作者你好，
我在调试代码的时候将衍射距离设置为10cm，光波长为530nm，其余条件与您1920未加padding的保持一直后，运行您的网络，发现loss基本不下降，重建的平均PSNR只有5左右。我更改衍射距离，发现10-13cm的PSNR都只有5左右，14cm能提高到26左右。理论上在衍射距离设置为10cm是满足ASM要求的，也不存在衍射角度过小的问题，请问为什么会出现这样的问…