-
Using a bme that is probably broken (wrong vcc gnd connection)
the system simply reboots and only shows the initialization of the credentials... the failure manifests in the start_bme funcion from i…
-
Auf der Personenseite gibt es eine Information zu den Verbundenen Autoren:
https://ixtheo.de/AuthorityRecord/610247964
Wenn man darauf klickt, werden Sie in einer Liste angezeigt:
https://ixtheo.…
-
There is a need to further qualify a relationship.
At this state familial relationships are expressed via 28 agrelon properties. But there are more, not standardized and not only familial, relationsh…
-
Hallo. Ich habe ein MPCNC Nano Estlcam Shield V1.4 . Steuerung Estlcam. Ich brauche externe Treiber TM542T. Mit dem Shield und den externe Treibern laufen die Motoren wunder bar. Nun habe ich das Till…
-
I'm trying to connect my led strip WS2812b to an Raspberry pi 5. As i execute the example code, an SPI Device is opened, but no led on. I have connected the three wires of the led strip to the 5V, GND…
-
I ran into a snag with the output of gowin_unpack.py when trying to synthesize it in the Gowin IDE.
The IDE fails with an error on ALU definitions like this one:
ALU R2C6_ALU_0
(
.SUM(R2C6_F0)…
-
### CircuitPython version
```python
Adafruit CircuitPython 9.1.4 on 2024-09-17; Adafruit Matrix Portal M4 with samd51j19
```
### Code/REPL
```python
from adafruit_matrixportal.matrix import Matrix…
-
See page [Lolin S3 PRO](https://circuitpython.org/board/lolin_s3_pro/).,
section: ```Install, Repair, or Update UF2 Bootloader```.
Note that ```Button 0``` standard is not connected to GND.
My ex…
-
**Panel description:**
LED P5 OUTDOOR RGB SMD2121 HUB75 64x32 1/8 Module
**Dimensions (in pixels):**
64x32
**Scan factor:**
1/8
**Chips on rear side:**
ICN2012, ICN2037BP, MW245B
![CHIPO…
-
If the ground pin location is arbitrary, I'd choose the RS232 location for it: pin 5