-
i have a controller that uses state machines and I was hoping to be able to represent them using the homie convention.
Here's a simple example:
![mermaid-diagram-2024-11-01-095617](https://githu…
-
### Checklist
- [x] The title of this issue is "to the point" and descriptive.
- [x] This issue describes what is happening.
- [x] This issue describes what components are affected (e.g. name of pl…
-
In #120 some Attributes were removed:
* $fw/name
* $fw/version
* $localip
* $mac
Lets discus about how to reimplement them, but also reimagine these attributes.
### FW:
This was discussed t…
-
as per title
-
I have successfuly discovered a LIFX lamp connected to Indigo.
When I update the dim value in Indigo, this is sent to HE (just updating /dim with a payload of the dim valuee.
The value is correctly …
-
Hi Kevin,
Does the **$type** have any significance to the MQTT App or does it just use $properties to determine the device's capability e.g. **onoff, dim**.
If it is significant, is there an app…
-
Hello,
Great project. Thank you very much for all your hard work.
I am trying to retrieve the current state of each node property on-demand but not able to find one.
It's publishing the stat…
-
I would like to have one firmware that has code for all the sensors that I use, and then to use the configuration settings to decide which to enable (d1 wemos, and non-technical users)
```
SensorN…
-
Currently, as of pre24b, homie discovery must be enabled to '`Run everytime app starts`' and an app restart then done, afterwards it can be disabled from that should you wish.
![image](https://user…
-
This issue is just a feature request and an attempt to get a general opinion about this idea.
I'm using Homie to transfer and log measurement data. Currently nodes only operate and send data when a…