-
It would be nice to be able to control the fan speed based on the current humidity level so it isn't too noisy when the desired humidity is relatively close and if I am not home.
This is for https:…
-
Hi, First of all thnx for all for this project. I successfully assigned all the itho values via mqtt to home assistant. I have a question:
Is it possible to emulate the CO2 value or Humidity value …
-
### The problem
Whenever I try to set a humidity set point for the service nexia.set_humidify_setpoint, I get a timeout error and the expected humidity value is not updated. Current thermostat seem…
-
Please include the humidity indicator that is located in the bottom right hand corner of the AMS screen in the Handy App.
-
Hi,
I think (again stupid me for thinking) that it might be useful for people to use this thermostat in DRYer mode only.
Reason is that is might be dumb to switch on dehumidifier while window OR do…
-
It would be very useful for Infodengue to have tables with climate statistics already aggregated by epiweek and by municipality, health region or state.
Variables:
- average min temperature
- …
-
Hi
since the core update 2024.7.0, I no longer see mushroom chips. if I change vertical-stack-in-card to vertical-stack or stack-in-card the mushroom chips show fine.
![image](https://github.com/ofe…
-
The units label for specific humidity RMSE (and MAE, MSE etc) plots is "g/kg" but the values are roughly 1e-3 which suggests the data being shown is actually in units of "kg/kg".
For example:
-
In this Notebook **1_mfr_mlflow.ipynb** :
1. No Table named HUMIDITY_UDI in Snowflake, SO i changed it to HUMIDITY
2. There is no "UDI" ID Column fo this table : HUMIDITY
Remark : the usage of S…
-
Ideally we should use the `Climate` API but obviously this would be device specific. The way I was thinking was that if I use Climate to set the desired humidity to 45% then the following should occu…