-
### The problem
Hi running the ESPHome config for the BME680 with the BSec as per instructions.
All seems to be working and levels are the same as previous configuration.
BUT with the new BSec and…
-
Use a block?
-
### Description of defect
As part of https://github.com/arduino/nicla-sense-me-fw/pull/85 , new sensor IDs have become avaliable for use on the Nicla Sense ME. These include the following:
`…
-
Hi,
I'm still trying to use the Bosch lib for reading values of the BME680 (precisly to get the IAQ calculated by the BOSCH lib). Unfortunately the IAQ is stuck at 25 (and IAQ-Accuracy is at 0), wh…
-
### The problem
my BME680 sometimes stops working, the BH1750 that is on the exact same wires keeps working however.
Their pins on these sensors are exact reverse so the wires and sda-scl resistor…
-
Hi Maarten!! just read IAQ-core P datasheet from AMS ans they talk about use 4k7 Ohms resistors with SDA / SCL and VCC.
I want to mount one IAQ and would know if u use the resistors berfore mountig.…
-
### The problem
I have a [SparkFun Thing Plus](https://www.sparkfun.com/products/17381) that I use as a garage door controller. Up through 2022.11.5, the wifi has been rock solid. On 2022.12.0 and …
-
### The problem
To get the camera to work in this board you need:
https://github.com/Freenove/Freenove_ESP32_S3_WROOM_Board
![Freenove_ESP32_S3_WROOM](https://github.com/Freenove/Freenove_ESP…
-
# Describe the problem
The values for the gas sensor and air quality are not displayed on the Nicla Sense ME dashboard and are always zero.
![image](https://user-images.githubusercontent.com/756…
-
I looked into the code and couldn't find the path for the state file to be stored.
It seems that as data was never saved to the state file the IAQ accuracy measurement will reset to '1' for more t…