-
Happy New Year,
The "older" ` ipaddress/simulator.html` makes it possible to access the `System SetUp` however the connection is lost when scrolling either to fast or selecting some of the settings. …
-
Hey @galletn,
Thanks for your work on this.
For some reason iaqualink is the only HACS plugin that I have that can't be updated through the Home Assistant UI.
I have to uninstall and then rei…
-
Hi,
Just wondering if you have found the screen scraping to be reliable enough to use?
thanks,
Craig
-
I have AqualinkD set up with my Jandy LEDs using the Aqualink panel to set the color (lightMode = 0), however, Aqualink is unable to cycle to the correct color unless I shutdown the aqualinkd service.…
-
I have a Jandy RS board (Yg / 4.3.13 firmware), that was the upgrade for the iAqualink 3 (since I previously had a PPD PDA chip). I also have a Century Variable Speed Motor (that acts like an ePump on…
-
EDIT: Not an HA issue, resolved by going to iAqualink, changed password, deleted existing Hub in HA, added new one with updated PW and everything was working again - in case someone else experiences …
-
### The problem
Hi,
I've been attempting to integrate iAquaLink into my Home Assistant setup by following the steps on your website: https://www.home-assistant.io/integrations/iaqualink. However, …
-
My system is an RS8 that has the wifi interface. Is it possible to use aquaklinkd with the IP address of the iQ20-RS?
-
I just got started and am using an EW11 to connect back to my home network which I have AqualinkD running in two containers, one so I can run serial_logger and one to run aqualinkd. The reason for th…
-
Updated to v2.2 . Without config changes, it seemed to start fine. Came back a bit later and made the recommended config changes for AqualinkTouch support instead of OneTouch, Panel Type, and Time Sy…