-
Note that for example, on the zc706, the path to the xadc temperature device is like so:
```
/sys/devices/soc0/amba@0/f8007100.ps7-xadc/iio:device0/in_temp0_raw
/sys/devices/soc0/amba@0/f8007100.ps7-…
-
Hi, first thank you for your work. I would appreciate some assistance with the lid flip functionality to detect the tablet mode. My current expectation is to be able to receive an event that has detec…
-
If the iio-trig-sysfs kernel module is not loaded, the below error message occurs:
INF: ./src/lib/io/sol-iio.c:344 check_trigger() No current trigger for iio:device0. Creating a sysfs one.
WRN: ./src/…
-
Hello,
I know it is possible to use iio devices in burst mode setting the kernel buffer to 1.
Is there a way to use gr-iio sink blocks in burst mode?
Thank you.
Ivan
-
Hello,
Every time I start the orientation program a driver crashes and the devices under /sys/bus/iio/devices/iio disappear.
I cannot start the orientation program again until I reboot.
Will this b…
-
If I were to write a sysfs attribute, in most cases, `cat`ing it back should result in the same data I wrote, plus a newline being printed. Unfortunately, there doesn't seem to be a way to mock that b…
-
Instead of hardcoding an IIO file for the ADC we should really iterate on the IIO devices of type ADC and then use that. Secondly it should be possible to ask for a number of AIO reads instead of one …
-
Hello,
I am on my FW16 and I installed the service via paru from AUR. It was installed correctly, my config was edited but it does not do anything. My brightness stays at the same level. However, the…
-
_**copied from comment on closed issued https://github.com/adafruit/adafruit-beaglebone-io-python/issues/269#issuecomment-610604001**_
@krupal756 wrote:
>
> This is my first time on github
>
> I …
-
hello guyz,
i am running gps-sdr-sim source code with plutoSDR on linux ubuntu. i am facing issue while transmitting. it shows like transmit starts but then no output has been shown and then done. …