-
### Operating system
Windows 10
### Board used
Teensy 4.0
### Description of problem
During compilation get following user side exception:
"Please install Git client from https://git-scm.com/d…
-
I am using rtw_8822cu (build from this repo on 610e04fc38343dcdcef95475c1579efc07572f1f)
I set up an access point with NetworkManager and connected from another machine and left iperf3 running. Aft…
-
https://github.com/RobTillaart/INA3221_RT/blob/f29bffd44dbf9eacd14555b283be11ac4e13e4be/INA3221.cpp#L165
Isn't it supposed to be setCriticalCurrent instead of setCriticalCurrect?
-
root@sonic:/sys/bus/i2c/devices/i2c-32/32-0050# cat dev_class
2
root@sonic:/sys/bus/i2c/devices/i2c-32/32-0050# echo 3 > dev_class
[73752.477250] stack segment: 0000 [#1] PREEMPT SMP PTI
[73752.…
-
### Contact Details
jon.eyes@duncreggan.net
### What happened?
Mutliple current values displayed - only started on this version.
node has a single channel INA 219 current sensor used to monitor ba…
-
Reproduction on Orin Nano using a disk on the built-in m.2 slot, but probably not a mandatory requirement.
```bash
set -e
ROOT_PARTITION="/dev/nvme0n1p1" # replace this with the device of your ch…
-
Just checking on mA consumed during sleep -
for the current 'develop' branch using logging_to_EnviroDIY.ino, on sleep the current reduces to about 3.5mA after EnviroDIYLogger.systemSleep() is execut…
-
This code produce a response around 1sec per printing. How to resolve this issue?
```cpp
#include
#include "INA3221.h"
// Constants for the number of sensors and their addresses
const uint…
-
### Category
Other
### Hardware
Rak4631
### Firmware Version
2.5.8.2ba72c15
### Description
When trying to compile customized firmware (using a fresh clone of the master branch) for a device _b…
-
After hours running fine in `heat` mode, in one radiator measured temp was keeping increasing like if the valve was dead. Lowered temp by 2 degrees and the valve not reacting. Shut off command was iss…