-
This is very fresh off the press, but klipper now officially supports the Palette 2 via connected mode:
https://github.com/KevinOConnor/klipper/pull/4057
Before this feature, you would need to …
-
Hey @gdombiak i really love your work and the new AppleTV implementation. Can‘t wait to watch via TV. Last week i flashed my board to klipper and everytime i power on i have to restart the klipper Fir…
-
### Is your feature request related to a problem? Please describe.
Not having a reliable, easy to setup accelerometer for doing input shaping measurements on Marlin printers. As discussed here http…
-
**Describe the bug**
Internal error during connect: cannot import name signature error message. If i comment out all autotune rows in the printer.cfg the printer can suddenly connect again
**To Re…
h3rm updated
4 months ago
-
Hey,
So I'm looking for a solution to install klipper on my Anycubic Kobra and Kobra Plus (as far as I'm concerened they have the same board), but I'm really new to electronics and GPIO pins espec…
-
**It isn't a bug**, I think will be good if have klipper configuration on plugin, like Square Corner Velocity, Pressure Advance, etc, because the time is stay wrong when I use original preset for my p…
-
### Cura Version
5.4.0
### Operating System
POP!_OS Linux 20.04
### Printer
RatRig V-Minion with Marlin
### Reproduction steps
click on Settings-Printers, see list of "network enabled" printers…
oliof updated
11 months ago
-
I have Klipper on an Anycubic Kobra 2 Neo, and its stock Auto Z-Offset has a little switch on the end of the bed. The stock firmware first probes the middle of the bed, and then goes over to the dedic…
-
### Requested feature:
When using the [Klipper virtual LEDs](https://github.com/MapleLeafMakers/klipper-virtual_leds) plugin, I would like to see the virtual LEDs listed on the web UI like "normal" n…
-
So i am gonna convert my Neptune 2 to Klipper and it would be nice to use the factory TFT screen with Octoprint as Klipper currently does not support touch screens. I will need to wire up the factory …