-
This is a great integration which I've used daily for the last few months for controlling the Hot Tub and for contributing to automations.
Version 1.6
Lay-Z-Spa Toronto
Following a brief power …
-
**Describe the bug**
When setting up device for the first time the AP is not enabled to setup (Lay-Z-Spa Module##### does not appear)
**To Reproduce**
erase flash and install latest release or be…
-
On the start page, the time of hydrojets is displayed incorrectly under Totals. The label and the value are displayed in the first column.
- Lay-Z-Spa Hawai
- Version: 2023-10-17-2132
S…
-
I've recently installed this to control my new hot tub but unfortunately can't get any actions to work.
It shows me all the relevant information, temperatures, heater/bubble status etc but if I try …
-
Hi during the middle of the night HA dropped the connection to CleverSpa and I can't get it to reconnect, even removed and re-added the integration. Mostly just wondered if it was just me 🤷...
This…
-
**Describe the bug**
After install board seems to be stable with no issues until I select 4wire 54138 on CIO and DSP and reboot. While the board is idle (not even connected to pump) it will periodica…
-
### System information
Type | Version/Name
--- | ---
Distribution Name | Armbian Buster
Distribution Version | 21.05.2
Linux Kernel | 5.10.34-meson64
Architecture | aarch64 (S905X3/Cortex-A55)…
-
**Hardware (please complete the following information):**
- Pump S100102
- 6 wires
- PCB V1 with 510 Ohm resistors between lines
- Level shifter type Blue one
**Software (please complete th…
-
[24.08.2023 12:09:09] jasiu-rozowyczlowiek:
[24.08.2023 12:09:09] jasiu-rozowyczlowiek
-
Hello,
I am hoping to make this project work for my spa, but am having issues with the code. When try to connect to the lazyspa.local url using the provide credentials, my board goes into some sort…
1NewC updated
5 months ago