-
Hi Pierre,
I was successful in using acan2517 lib on Arduino nano with MCP2518FDClick board as sender and UNO with MCP2515 as receiver. I am unable to do the same with pico development board, The p…
-
Hello, I'm trying to use [LilyGO T-CAN485](https://github.com/Xinyuan-LilyGO/T-CAN485) to connect to a DC Battery CAN BUS. I'm trying to figure out how to customize the ESP32RET.ino to work with thi…
-
Shouldn't the sample code,
ACAN2517FD can (MCP2517_CS, SPI, MCP2517_INT);
instead instantiate the class:
ACAN2517 can (MCP2517_CS, SPI, MCP2517_INT);
This library seems to be for Classic can (no…
-
Thank you for this package. I really appreciate it!
I am transmitting a message on the CAN bus with the ID 0xFF0400. I have a CAN monitor on the line and it confirms that the message is sent out …
-
Hi!
Using an MCP2515 with interrupt connected to the ESP32 and also writing to EEPROM in my code I get this crash below. It depends a bit on timing but if an interrupt arrives around the time I'm…
-
Hi, thanks for sharing and maintaining this source code it really does the job. Currently Im using built in canbus with vd230 transceiver. I was wondering is it possible some how in easy way to add au…
-
Dear all
I'm trying to set up a board using Microchip's MCP2518 controller ([MCP2518FD CLICK Board](https://www.mikroe.com/mcp2518fd-click)) together with an Arduino Uno, but I can't get SPI commun…
-
Hi
First, thank you Pierre for this great, very well documented, library.
It runs very fine on Arduino UNO + Mikroe Click board MCP2518FD.
I'm now trying to run the library on Raspberry PICO …
-
Hi,
I tried these commands:
_from canpico import *
c = CAN()_
Then it raised an error:
**RuntimeError: Cannot put MCP2517/18FD into config mode**
Any insight?
Thank you.
Regards,
Jh…
-
Hardware: NXP SOC i.MX 8M Min
OS: Linux kernel 4.14.98 + mcp25xxfd-V8.2
The following error messages are generated during a trasnsmission attempt:
[ 43.425070] BUG: using __this_cpu_add() in p…