-
### Issue:
After updating from version 1 (MKRWAN) to version 2 (MKRWAN_V2) of the LoRaWAN library in a MKRWAN1310 Arduino board. I've encountered difficulties in storing OTAA keys in memory and retri…
-
Does anyone know where can I get the official docs for the AT commands on the Murata chip? Each firmware has a different set of commands and there is no documentation available on this other than reve…
-
Using this command in my sketch on MKR1310:
Firmware: 1.2.1
```
connected = modem.joinABP(devAddr, nwkSKey, appSKey);
if (!connected) {
if(debug)Serial.println("Lora ABP Connection fa…
wapel updated
1 month ago
-
I'm trying connect my MKRWAN 1310 to The Things Network. I have a device configured for OTAA setup in the TTN and when I run FirstConfiguration and enter the APP EUI and APP Key, I actually see the d…
-
Is there any documentation on how to build and program the firmware? I would like to address the sleep issue. I've installed Eclipse and did a build all. Everything seemed to compile but I do not k…
-
Fw version compiled is 1.3.0 and not 1.3.1
-
Hi,
I'm testing the library with ABP and unconfirmed frames.
After a frame is successfully sent (say frame A), if one tries to send another one (say frame B) before the duty-cycle allows it, `modem.…
-
After updating the library and the FW accordingly, the receiving side (TTN) only gets empty messages. This is true for confirmed and for unconfirmed messages. OTAA join works, though.
![grafik](htt…
-
I am pretty sure that the Murata module has AT command support for this, but it does not seem to be an available choice in the Arduino sketches. If I look at the MKRWAN.h library, it would seem to be…
-
I have some more information regarding the underlying cause of this issue.
I think there is a problem with the confirmed packet ACK's. From what I can see so far, the module AT_Slave firmware send…