-
Currently, when stepping over a line of code, GDB will issue commands to step a single instruction at a time. This means there's a lot of back-and-forth with Bloom and GDB, which can have a significan…
-
The MPLab Snap can only program via the ISP interface with avrdude. With another open source application, bloom, it is possible to program via JTAG.
Is it possible to implement this in avrdude? Wou…
-
Avrdude supports some nice CLI features like read/write to stdin/stdout (-U) and piping into terminal mode, but none of these features are documented in the avrdude.texi file.
We should perhaps men…
-
From here
* https://github.com/avrdudes/avrdude/pull/1523#issuecomment-1784217877
@MCUdude found an issue with AVR EB support.
```
$ ./avrdude -cpkobn_updi -pavr16eb32 -qq -t
avrdude> read fuse…
mcuee updated
8 months ago
-
I have compiled avrdude from source because linuxspi is completely missing now from the prebuild binary in raspbian.
During configuration of the build it shows ENABLED for both linuxgpio and lin…
-
I added the following programmer to avrdude.conf to see if I could get JTAG programming to work. JTAG works just with both the PK4 and the SNAP in MPLAB X. I've enabled both the OCDEN and the JTAGEN f…
-
avrdude: Version 7.1-arduino.1
Copyright the AVRDUDE authors;
see https://github.com/avrdudes/avrdude/blob/main/AUTHORS
System wide configuration file is C:\Users\Pet…
-
Hey SpenceKonde, is this possible to do? I am able to load the hex, but the device seems to not be functional. When using an ATMEL ICE in Visual Studio, it works fine. I know you specify some programm…
-
Hi,
So, I managed to install DxCore and compiled the LED blink sketch successfully, but when I try to flash, I get the below error. I follow the wiring of the USB serial TX/RX, per the instruction…
-
For some reason, the serial number string is blank with the SNAP and PICkit4.
It does however work with pkobn_updi (nEDBG) and mEDBG boards.
@janegilruud is there a different command we have to us…