-
Hi there,
thank you very much for this library. We were hoping to use it in a project with a [RBL nRF51822](http://redbearlab.com/redbearlab-nrf51822/) and a small Neopixel ring, but all it does is t…
-
I love the compact NRF51822 "beacon" module that you're using in your picture - where can I find info on setting these up to write new firmware? Hopefully something step-by-step on where to solder con…
-
Servus Reisi,
bei der Helena hast Du im Code beim Einlesen der Spannung ein Teilungsverhältnis von 1/3 stehen. Die Beschaltung im Ctrl-Board ist 1/6 (100K + 470K).
Die App gibt bei anliegenden 8V im…
-
Hello. Thank you for this library.
I need help with deep sleep with board nrf51822.
Now for example "delay(5000);" get me about 0.8-0.9 mA.
Is this maximum mA for sleep mode?
-
Tested "Blink.ino", unable to link "mbed.h".
Appreciate your advice. Thx
Arduino: 1.6.5 (Windows 7),
Board: "RBL nRF51822"
In file included from Blink.ino:18:0:
D:\arduino-1.6.5-r5\hardware\RBL\RBL…
-
Hello,
I am a beginner in arduino and I will want to use the NRF51822 module that I bought from aliexpress with the waveshare development card but I don't know how to connect the SDA and SCL pins of …
-
The [generic CJMCU-8223 board](https://www.aliexpress.com/i/2255800707216773.html) uses an nRF51822, the same as the Adafruit blefriend32 boards. The Nordic sniffer firmware used on the pre-flashed Ad…
-
Hi,
Let me start by thanking you for this project, when I seen the existing implementations of haystack I was fully prepared to instead roll my own in .NET, but your project made everything painless …
Paffo updated
3 weeks ago
-
-
The file reference: https://github.com/ARMmbed/cmsis-core-nrf51822/blob/master/source/cmsis_nvic.c#L33
There are comments which are not relevant plus code commented which is also not applicable to nr…