-
- [ ] Adjust Brightness
- [ ] Adjust Color
- [ ] Method read photoresistor
- [ ] Method: Use read method to set brightness if auto is on/true
- [ ] Method: Set timer for bulb
-
We are searching for an easy way to attach a light sensitive sensor to your robot to follow or avoid light.
LDR sensor can be used.
-
sorry I forgot when I was here last to ask you how to set your code to minimalistic? That being no seconds hand. The original project you covered the photoresistor for two seconds, it looks like here …
-
Did you find same traces for LED controlling? I can see some pins labelled LED_G and LED_R...but i can't figure out what's the purpose and if i can use GPIO or need a relay... btw where is the Yellow?…
-
I've recently flashed this firmware on a brand new chip and I noticed that depending on the light received by the photoresistor the display flickers. Is that the normal behaviour? In light and darknes…
-
# Background
A photocell is a type of resistor that changes it's electrical resistance based on the amount light shining upon it.
# Proposed Identifier
- **photocell**
# Proposed States
- **ready**
-…
-
What's the purpose of `Ext LDR` in the schematic (light sensor maybe) and what is the exact type of component to be used?
-
The first technical step is to set up a single sensor to connect through an Arduino using Johnny-Five to a laptop. This will resemble the [example](http://site2site.github.io/lectures/week3/example.ht…
-
Add BOMs:
- [x] Driver board
- [x] Motherboard
-
How would I modify this for opening and sensing two doors?