-
## Software
- https://k3s.io/
- https://kubernetes.io/docs/setup/production-environment/tools/kubeadm/install-kubeadm/
- https://datasheets.raspberrypi.com/rpi5/raspberry-pi-5-product-brief.pdf
- …
-
#### Overview of the Issue
Is the Zero 2 W supported? I have tried the premade image for the pi3 but the zero 2 won't boot with it. I have tried Pi OS Lite 64bit Bookworm and Bullseye. They both han…
-
# Issue
I installed osrm-backend v5.28.0 on my Raspberry Pi 4 running Debian Bullseye in the 64 bit version. So in theory, the system should be able to deal with OSM IDs higher than 4294967295. How…
-
Hi, i tried installing this in raspberry pi os 64bit version but it doesn't seem to work in 64bit architecture, however in 32bit it works just fine, if you could add support for 64bit also that'd be a…
-
Sorry for my english, I'm using google translate.
On my raspberry pi 4 i installed raspios bullseye 64bit. I installed docker following the official guide and installed Home Assistant Supervised on D…
-
This is a: BUG
## Details
In my a docker environment, even though the Pi-Hole is supposed to be disabled (in the attachment, chosen **indefinitely**) I then try to access sites that are block…
-
I reinstall Raspberry Pi OS (64bit) on my Raspberry Pi 4 with an Geekworm NASPi (NOT Lite).
I installed the script like shown in the wiki, but **xoff** is not working. Every time I type this in conso…
-
The installation fails on a 64bit raspbian installation.
The reason in my opinion is that the binary is 32bit and therefore cannot be executed on the 64bit version of the os.
Since 64bit was officia…
-
Hello there,
I'm new to rotor hazard. I have a setup of Raspberry PI Zero 2W with Arduino and the receiver.
However I have some problems to do an initial install. I installed RaspbianOS lite …
-
Ansible fact or create new fact for Pi board revision? Looking for a way to run specific ansible tasks based on the Pi device being 32 or 64 bit. For example setting config.txt arm_64bit=0 or 1?