-
My Sonoff POW using Espurna 1.13.0 doesn't show any active Power/Current/Voltage (in the status screen).
As for the calibration (Sensors screen), when I enter the expected Power/Current/Voltage the…
-
Hello to all :)
I have a problem with overshooting very frequent, I tried to change many settings in esphome but without results :/
I have 3 inverters with 1 rs485 bus for to sync them, esp32 mini…
-
@gemu2015
Some discussion on Discord re: 3-phase power monitoring with Tasmota. In particular, using multiple inexpensive PZEM-004T modules. I suggested that perhaps the smart meter interface you …
-
Hello,
I have problem with PZEM004T, Platformio dont compile the code, I get an errors:
espurna/config/../sensors/PZEM004TSensor.h:131:23: error: expected identifier before numeric constant
espur…
-
This is more like an RFC than a bug report, sorry for spamming issues for that.
Did some research into adding a voltmeter to openevse 5.5 hw. I am aware of OpenEVSE II but that looks like a history…
-
I have used the library to work with Arduino UNO and it works fine.
With my Nodemcu-32S board, I am not able to get anything on the serial monitor when I run "PZEMHardSerial" example with "&Serial" i…
-
Hello
I bought 3 pzem-004t 10A and then 3 others of 100A. I gave the addresses 1, 2, 3, 4 to the first but impossible to give the addresses 5 and 6. When I give an address >4 the pzem takes the addre…
-
### The problem
He conectado a los pines RX0 y TX0 sus correspondientes al PZEM-004T V3 (TX y RX) de 100A respectivamente. Sin embargo recibo los siguientes mensajes de error:
22:49:17 | […
-
### BUG DESCRIPTION
After update 6.6.0.15-2.5.2 the PZEM004T no value is shown.
- [x] Read the [Contributing Guide and Policy](https://github.com/arendst/Sonoff-Tasmota/blob/development/CONTRIBUTI…
-
Having just read about the support for PZEM004T Energy Monitor from Peacefair. I'm just wondering if it will be possible to add support for PZEM-003 and PZEM-017 DC meter with RS485 from same manufact…