-
### Description of defect
Nucleo WL55JC board is recognized and can be flashed without any issue but once flashed, any program does not seems to start, I tested blinky also without any success.
…
-
my circuit diagram is an esp32 s3 connected Serial1 to rak3172 wisduo board of Serial1. I can send data over UART each others . But I couldn't get your library to work in this setup. what should be pr…
-
### SOC
Other
### Lora IC
SX1262 (inside STM32WL)
### Product Link
https://www.seeedstudio.com/LoRa-E5-mini-STM32WLE5JC-p-4869.html
### Description
There is currently a variant of the firmware …
-
### Setup:
NucleoWL55JC
The latest version of this project [8a8140f](https://github.com/STMicroelectronics/STM32CubeWL/commit/8a8140f342a3d0ac85e5a02f44db8782765a7bed)
### IDE:
STM32CubeIDE 1.10…
-
I kindly request support for the RAK3271T module.
Existing variant RAK3271 worked fine for the module RAK3271E and RAK3271S. The RAK3172T module has an TXCO installed for a lower operation tempera…
-
### Description of defect
Not be able to use AS923 region, no OTAA received on gateway on frequency 923.2Mhz and 923.4Mhz
#### Target(s) affected by this defect ?
STM32WLE5 RAK3172
###…
-
Hello sir,
I am experiencing an issue with the Canopus version 1 board. The Modbus Master example code available on GitHub is not working, and my own code that uses the frames is also not working.
…
sl446 updated
6 months ago
-
### Description of defect
Inability to enter sleep mode (or at least reach expected sleep mode average current) after calling
`static LoRaWANInterface lorawan(radio);` when working with NRF52…
-
Hi a Nam,
I tested your example code Rak3172 working as **Modbus slave** but it's doesn't work,
I am using your example and **Modbus Poll** working as **master** for reading data from **Rak_v1**
…
-
Hello,
I am working on a port of this code for the STM32WL in a RAK3172. I have noticed that the following Tx and Rx functions in the new relay code do not explicitly set the antenna direction with …