-
Hi @dimer47 ,
thank you for your work !
I'm looking for a Homebridge plugin which can replace my Gaposa remote control for my awning motor.
The RFXCom does communicate with it.
I've retrieve t…
-
For those who are looking to use rtl_433 in place of rfxcom to decode RFXMeter frames here is the decoder.
Didn't find something here.
Some incertainties about the packet's end.
Sometimes it's ne…
dblas updated
3 months ago
-
Try to control a 433MHz wall plug with the rfx-light node.
![image](https://user-images.githubusercontent.com/56399751/208901468-706d6315-878f-4159-897a-bb5c9ca6cd2a.png)
But the rfx-light node will…
-
I have an RFXcom to control my Mertik fireplace. Domoticz fully supports this: on/off, higher/lower flame etc. See below for a screenshot of how the switch shows up in Domoticz.
Using edomoticz…
-
Background: The mode of the RFXtrx is used to enable and disable different protocols and/or manufacturers. Therefore, we need to make sure the protocols we are using are enabled. The `status` packet r…
-
I have a RFXCOM rfxtrx433e and I'm trying to use the rfxcom binding to control my Dooya curtains motor.
I managed to pair the rfxcom with the motor using rfxmgr program by following the instructions…
-
Bonjour,
A l'aide du plugin je parviens à allumer des lampes mais pas mes volets. Pourtant lorsque je copie l'URL http://192.168.0.X.X:XXXX/json.htm?type=command¶m=switchlight&idx=10&switchcmd=On…
-
I've got an RFXtrx433E running on RPi #1 (receiving temperature & humidity sensors, and connected to Domoticz), and I've shared the USB port with RPi #2 - which is where I run Node-RED - using ser2net…
-
![201712358_0912-00](https://user-images.githubusercontent.com/34807788/34325405-f61399f4-e890-11e7-86ff-3de312dfccb7.png)
`{
"ActTime" : 1514105861,
"ServerTime" : "2017-12-24 09:57:41",
…
-
I have an LW201 that I am trying to add to Homey. I select the device from the app and it tells me to press the On button, which I do, but nothing happens in the wizard.
If I use the Development tool…