-
(To those working on omxplayer (and the RPi project) many many thanks.)
The RPi and omxplayer are being used to display IP security camera streams, but its low power means it cannot keep up in re…
-
Hello, I am trying to get RPISurv to work on a raspberry pi to output RTSP streams from Digital Watchdog, but I am unable to get the service to start. Below is the output of sudo systemctl status rpis…
-
i can not complete the installation of rpisurv, any solution?
Output after try to install...
```
Your version of vlc does not have the needed mmal options. Rpisurv needs those
Minimum tested v…
-
I'm trying to have 2 camera streams appear on screen in 1 column, but when they both load, and i have to force tcp to get them to, they don't refresh. They don't get detected as dead streams, and i c…
-
Good Day
I just installed a fresh rpisurv on my pi loaded with Pi OS Legacy
When I boot up my Pi it loads into a black screen and stays on the black screen. If I ssh into the Pi and "systemctl r…
-
I am using Reolink RLC-410-5MP cameras. The low resolution feeds work fine, but if I try to use High resolution feeds the image tearing is unviewable.
Looking in `/var/log/syslog` I see the follow…
-
Hey Sven,
Unfortuantely pisurv stopped starting on one of my pi's I moved it and plugged into hdmi 1 not 0 but soon corrected .
Jul 05 09:54:12 shedrstppii rpisurv[932]: Hello from the pygame co…
-
hi im new on this i follow the steps but i can make it work i have a raspberry pi 4 with a 7' touch screem, thanks 800x400
pi@raspberrypi:~ $ sudo systemctl status rpisurv
● rpisurv.service - Rpis…
-
Thanks for the software, I sent a donation via Transaction ID: 59E98827UW3292817
Please close this as I should have used tapatalk to communicate success on Bullseye and RPI 4.
-
Hi All,
im not sure what to do about this but im having an issue where after its running for a few hours, its starts memory leaking
so much so its crashing my pi hard withint 24hours
its a Raspberr…
si458 updated
9 months ago